7
6 Cleaningthe
humidificationfilter
Clean the humidication lter every week to
keep it hygienic.
1 Switch off the humidier and unplug it
(g j).
2 Hold by both sides of the upper unit and
lift it up (g b).
3 Take out the humidication lter and the
lter support from the water tank (g k).
4 Remove the humidication lter from the
lter support (g l).
5 Soak the humidication lter in tap water
for one hour (g m).
6 Rinse the humidication lter under a
slowly running tap (g n).
7 Let excess water drip off the
humidication lter.
8 Assemble the humidication lter round
the lter support (g d).
9 Put the humidication lter and the lter
support back into the water tank (g e).
10 Place the upper unit back onto the water tank
(g g).
Note
• Do not squeeze or wring the lter. This might
damage the lter and impact humidication
performance.
• Do not dry the lter under direct sunlight, unless
it is assembled back onto the lter support
7 Replacingthe
humidificationfilter
Replace the humidication lter every three
months for optimal performance. If the lter
is in good condition, you could use it for a
longer period of time. Make sure to replace the
humidication lter at least once a year.
Note
• Use only Philips original humidication lter
HU4102.
Tip
• Register your product at www.philips.com for
further information on how to replace your lter.
1 Switch off the humidier and unplug it
(g j).
2 Hold by both sides of the upper unit and
lift it up (g b).
3 Take out the humidication lter and the
lter support from the water tank (g k).
4 Remove the humidication lter from
the lter support. Discard the used lter
(g o).
5 Remove the packaging material of the new
humidication lter (g c).
6 Assemble the new humidication lter
around the lter support (g d).
7 Put the lter and the lter support back
into the water tank (g e).
8 Place the upper unit back onto the water tank
(g g).
Tip
• You can easily nd more information about how
to replace the lter in our web page or by calling
our Consumer Care Center.