Philips IRT 9090 - Daylight Calibration

SpaceWise for Industrial Applications
v. 1.6
Philips Lighting North America
22
11. Daylight Calibration
Daylight calibration should be performed during night time. Daylight calibration is set
for all the luminaires in the group. These instructions will only work on an industrial
application mode and not on an office application mode.
a.
Point remote to any luminaire and press
“unlock,” once.
Wait for LED to stop blinking (apx. 10
seconds).
Point remote to any of the luminaires
and press “send.”
Red LED on remote will start
blinking.
Red LED on remote will stop
blinking.
The luminaire will FLASH twice
and group light level will go to
50%.
b.
Point remote to any of the luminaires
and adjust the group light level to the
required level using the dimming “up” or
“down” arrow keys
When the arrow keys are
pressed, red LED on remote will
keep blinking.
The group will dim up or down
accordingly.