SpaceWise for Industrial Applications
v. 1.6
Philips Lighting North America
Verify the group by pointing to any of
the luminaires in the group and pressing
“on” and “off.”
All the luminaires in the group
will turn ON and OFF together.
If any luminaires in the group do not turn ON/OFF, they are not part of the
group. Go back to step “a” to add the luminaires back in to the group.
Point to any of the luminaires in the
group and press “lock.”
Wait for LED to stop blinking (apx. 10
seconds) then press “send.”
Red LED on remote will start
blinking.
The luminaire will FLASH twice.
Group is ready for normal
operation.
Once the group is locked it will not accept any configuration changes. To
make any changes the group has to be unlocked first. In order to save time,
you can choose to lock the group after finishing all configuration changes
such as max light level changes, scene customization, etc have been
executed.
Refer to the FAQ section for additional information on how to correct non
responsive luminaires.
To Next Page
Loading...
