Alignments
EN 83LC4.41E AA 8.
8. Alignments
Index of this chapter:
8.1 General Alignment Conditions
8.2 Hardware Alignments
8.3 Software Alignments
Note: Figures below can deviate slightly from the actual
situation, due to the different set executions.
General: The Service Default Mode (SDM) and Service
Alignment Mode (SAM) are described in chapter 5. Menu
navigation is done with the Cursor Up, Down, Left or Right keys
of the remote control transmitter.
8.1 General Alignment Conditions
Perform all electrical adjustments under the following
conditions:
Mains voltage and frequency: 220-240 V / 50/60 Hz.
Allow the set to warm up for approximately 10 minutes.
Test probe: Ri > 10 MΩ; Ci < 2.5 pF.
8.2 Hardware Alignments
There are no hardware alignments foreseen for these models.
8.3 Software Alignments
With the software alignments of the Service Alignment Mode
(SAM) various settings, like white tone and tuner (IF) can be
aligned.
To store the data: use the RC button Menu to switch to the main
menu and next, switch to ‘Stand-by’ mode.
To Next Page
Loading...
Need help?
General
