-
Never use compressed air, scouring pads, abrasive cleaning agents
or aggressive liquids such as petrol or acetone to clean the device.
-
The scattered light produced by the device is harmless to your
eyes. Do not look at the flash while using the device. It is not
necessary to wear goggles during use. Use the device in a well-lit
room so that the light is less glaring to your eyes.
-
Always return the device to a service center authorized by Philips
for examination or repair. Repair by unqualified people could
cause an extremely hazardous situation for the user.
-
Never leave the device unattended when it is switched on. Always
switch off the device after use.
-
Do not use the device if any of the conditions mentioned in
chapter ‘Who should not use Lumea? Contraindication' apply to
you.
-
Tanning with natural or artificial sunlight might influence the
sensitivity and color of your skin. Perform a skin test to determine
the appropriate light intensity setting.
-
Before you use Lumea, you should clean your skin and make sure
it is hair-free, entirely dry and free from oily substances.
-
Do not treat the same skin area more than once during a session.
This does not improve the effectiveness of the treatment, but
increases the risk of skin reactions.
-
Lumea should never be painful. If you experience discomfort,
reduce the light intensity setting.
Electromagnetic fields (EMF)
This Philips device complies with all applicable standards and regulations
regarding exposure to electromagnetic fields.
12
English
To Next Page
Loading...
Need help?
General
