Philips Lumea Prestige - Two Treatment Modes: Stamp & Flash and Slide & Flash

22
English
Note: To adjust the light intensity setting manually without using the
SmartSkin button, use the toggle button until you have reached the required
setting. The corresponding intensity light level lights up white.
2 Press the SmartSkin button and put the device to your skin.
3 After the device has scanned your skin, the light intensity indicators will blink
white to indicate which intensities are most comfortable based on your skin
tone.
4 Press the confirmation button to confirm that you want to use the
indicated setting.
Lumea automatically uses the highest indicated intensity, which is shown by a
blinking intensity indicator.
Lumea gives you the freedom to select the light intensity that you find most
comfortable. Skin sensitivity can differ per person. Therefore, the skin test is
the most important guide for selecting your light intensity setting (see 'B Test
skin 24 hours before treatment').
5 Using Lumea should never be uncomfortably painful. If you experience
discomfort, reduce the light intensity setting. You can do this by using the
toggle buttons.
Note: The device is automatically disabled when your skin tone is too dark
(dark, marked with in the 'Suitable skin tones' table at the start of the user
manual), to prevent you from developing skin reactions. The ‘READY to flash’
light will blink orange to indicate if the skin tone is too dark.
6 After moving to another body area or sun exposure or tanning (see 'Using
your Lumea before and after sun exposure or tanning'), perform a skin test to
determine a comfortable light intensity setting. To re-activate the setting
indication feature, press the SmartSkin button .
Note: Perform a skin test before you start to treat another body area or after
a skin tone change. Determine the light intensity setting for each body area
separately.
Two treatment modes: Stamp & Flash and Slide &
Flash
YourPhilips Lumea has two treatment modes for more convenient use on
different body areas:
-
The Stamp & Flash mode is ideal to treat small orcurvy areas like knees and
underarms. Simply press and releasethe flash button to release a single flash.