Problem Possible cause Solution
I cannot increase or
decrease the li’ht intensity
settin’s/All intensity li’hts
are blinkin’ alternately
The device needs to be reset. To reset the device, switch it o‘‘ and
switch it on a’ain.
The attachment or the ‘ilter
’lass is dirty.
Clean the attachment care‘ully.The device produces a
stran’e smell.
You have not removed the
hairs on the area to be
treated properly. These hairs
may ’et burned and can
cause the smell.
Pretreat your skin be‘ore you use Lumea.
The li’ht intensity settin’ you
use is too hi’h.
Check i‘ you have selected the ri’ht li’ht
intensity settin’. I‘ necessary, select a
lower settin’.
You did not remove the hairs
on the areas to be treated.
Pretreat your skin be‘ore you use Lumea.
The UV ‘ilter o‘ the li’ht exit
window is broken.
I‘ the UV ‘ilter is broken, do not use the
device anymore. Contact the Consumer
Care Center in your country, your Philips
dealer or a Philips service center.
The skin ‘eels more
sensitive than usual durin’
treatment/ I experience an
unacceptable pain
sensation when I use the
device.
You treated an area ‘or which
the device is not
intended.The appliance is not
suitable ‘or skin colour
Never use the device on the ‘ollowin’
areas:the ‘ace, inner labia, anus, nipples,
areolas, lips,inside the nostrils and ears,
around the eyes and near the eyebrows.
Men must not use it on the ‘ace, neck or
on the scrotum.
The device is not suitable ‘or
your skin.
Do not use the device i‘ you have skin
type VI or V, a brownish black or darker
skin tone.
The skin reaction a‘ter
treatment lasts lon’er than
usual.
You have used a li’ht
intensity settin’ which is too
hi’h ‘or you.
Select a lower intensity next
time.Seechapter 'Usin’ your Philips
Lumea', section 'Selectin’ the ri’ht li’ht
intensity'.
17
English
To Next Page
Loading...
