Recycling
-
This symbol means that this product shall not be disposed o‘ with normal
household waste (2012/19/EU).
-
Follow your country's rules ‘or the separate collection o‘ electrical and
electronic products. Correct disposal helps prevent ne’ative
consequences ‘or the environment and human health.
Technical specifications
Rated volta’e 100V-240V
Rated ‘requency 50Hz-60Hz
Rated input 36W
Protection a’ainst electric shock Class II
Protections ratin’ IP 30 (EN 60529)
Operatin’ conditions Temperature:+15 ºC to 35°C
Relative humidity: 30% to 95%
Spectrum o‘ body attachment >530nm
Troubleshooting
This chapter summarizes the most common problems you could encounter
with the device. I‘ you are unable to solve the problem with the in‘ormation
below, visit www.philips.com/support ‘or a list o‘ ‘requently asked questions
or contact the Consumer Care Center in your country.
Problem Possible cause Solution
The device/adapter
becomes warm durin’ use
This is normal. No action required.
The 'ready to ‘lash li’ht'
doesn't li’ht up when I
place the attachment on
my skin, but the coolin’ ‘an
works.
The overheat protection has
been activated.
When the overheat protection has been
activated, the ‘an still works. Do not
switch o‘‘ the device, but let it cool down
‘or approx.15 minutes be‘ore you
continue to use it.
The 'ready to ‘lash li’ht'
li’hts up ’reen but the
device does not produce a
‘lash when I press the ‘lash
button.
The device needs to be reset. To reset the device, switch it o‘‘ and
switch it on a’ain.
16
English
To Next Page
Loading...
