2
Important Note
Important notes for users in the U.K.
Mains plug
This apparatus is fitted with an approved 13 Amp plug.
To change a fuse in this type of plug proceed as follows:
1. Remove fuse cover and fuse.
2. Fix new fuse which should be a BS1362 5 Amp, A.S.T.A. or
BSI approved type.
3. Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it
should be cut off and an appropriate plug fitted in its place.
If the mains plug contains a fuse, this should have a value of
5 Amp. If a plug without a fuse is used, the fuse at the distri-
bution board should not be greater than 5 Amp.
Note: The severed plug must be disposed off to avoid a possible
shock hazaed should it be inserted into a 13 amp socket else-
where.
How to connect a plug
The wires in the mains lead are coloured with the following
code:
blue = neutral (N)
Brown = live (L)
As these colours may not correspond with the colour mark-
ings identifying the terminals in your plug, proceed as fol-
lows:
- Connect the blue wire to the terminal marked n or coloured
black.
- Connect the brown wire to the terminal marked N or
coloured red.
- Do not connect either wire to the earth terminal in the
plug, marked E (or ) or coloured green (or green and
yellow).
Before replacing the plug cover, make certain that the cord
grip is clamped over the sheath of the lead - not simply over
the two wires.
Copyright in the U.K.
Recording and playback of material may require consent.
See Copyright Act 1956 and the Performer’s Protection Act
1958 to 1972.
CAUTION
Use of controls or adjustments or performance of proce-
dures other than herein may result in hazardous radiation
exposure or other unsafe operation.
Manufactured under license from Dolby Laboratories. “Dolby”, “Pro-
logic” and the double-D symbol are trademarks of Dolby Laboratories.
Confidential Unpublished Works. © 1992-1999 Dolby Laboratories,
Inc. All rights reser’ved.
MANUFACTURED UNDER LICENSE FROM DIGITAL THEATER SYS-
TEMS, INC. US PAT. NO 5,451,942, 5,956,674, 5,974,380, 5,978,762
AND OTHER WORLDWIDE PATENTS ISSUED AND PENDING. “DTS”
AND “DTS DIGITAL SURROUND” ARE RESISTERED TRADEMARKS
OF DIGITAL THEATER SYSTEMS, INC. COPYRIGHT 1996, 2000 DIGI-
TAL THEATER SYSTEMS, INC. ALL RIGHTS RESERVED.
This symbol is intended to alert the user of the
presence of uninsulated “dangerous voltage”
within the product’s encasement that may be of
sufficient magnitude to constitute a risk of
electric shock to persons.
This symbol is intended to alert the user of the
presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
AVIS : RISQUE DE CHOC ELECTRIQUE PAS OUVRIR.
'
Norge
Typeskilt finnes på apparatens underside.
Observer: Nettbryteren er sekundert innkoplet.
Den innebygde netdelen er derfor ikke frakoplet
nettet så lenge apparatet er tilsluttet
nettkontakten.
For å redusere faren for brann eller elektrisk støt, skal
apparatet ikke utsettes for regn eller fuktighet.
Italia
DICHIARAZIONE DI CONFORMITA’
Si dichiara che l’apparecchio LX-700D Philips risponde
alle prescrizioni dell’art. 2 comma 1 del D.M. 28 Agosto
1995 n. 548.
Fatto a Eindhoven
Philips Consumer Electronics
Philips, Glaslaan 2
5616 JB Eindhoven, The Netherlands
IMPORTANT NOTE
To Next Page
Loading...
Need help?
Amplifier Section
