Philips LX8200SA Quick Use Guide

LX 8200SA
LCRSLSR
+
+
FM 75 Ω
S-VIDEO
CVBS
VIDEO OUT
AUDIO
AUX
IN
TV
IN
LINE
OUT
DIGITAL
OUT
CENTER
OUT
DIGITAL
IN
WOOFER
LINE OUT
SURROUNDFRONT CENTER
SPEAKER SYSTEMS (6 Ω )
CDR
AUDIO OUT
abc
b
0.31"
(8mm)
AUDIO
INPUT
MW
FM/MW
ANTENNA
Pr/Cr
Pb/Cb
Y
R
L
R
L
B
C
☞
SCART OUT
☞
A
Helpful Hints:
If your TV is not equipped with a SCART
connector, connect your TV through the
corresponding CVBS A or S-Video B output.
Use Pr/Cr Pb/Cb Y jacks C connection if your TV
can accept progressive signals (Progressive Scan
TV).
Notes: On the TV
- The CVBS jack may be labeled as Video, Composite or
Baseband and is usually yellow.
- The S-Video In jack may be labeled as Y/C, S-Video or
S-VHS.
- The Pr/ Cr Pb/ Cb Y jacks may be labeled as
Component Video In or YUV and are usually red, blue
and green.
Connect the DVD system and subwoofer to the power outlets only
after you have finished hooking up everything.
Use this simple and quick way to
watch your favourite DVD movie
and enjoy your Home Cinema
experience!
Subwoofer
Recommended Speaker Setup
Connecting Speaker Cable
12nc: 3139 115 22491
Quick Use
Guide
Quick Use
Guide
You can listen to normal TV
broadcast channels through the
home cinema sound system from
such an audio connection.
When listening to TV programmes,
you have to set the DVD system
to TV/AV mode in order for the
sound to be heard.
Helpful Hints:
Surround
right
Surround
left
front
right
front
left
Centre

Philips LX8200SA Specifications

Picture/Display

aspect ratio	4:3, 16:9
D/A converter (Picture/Display)	12 bit, 108 MHz

Sound

D/A converter (Sound)	24 bit, 192 kHz
frequency response	30-20000 Hz
signal to noise ratio	>95 dB
total sound power (RMS)	300 W

Loudspeakers

satellite speaker frequency range	120-50000 Hz
satellite speaker impedance	4 ohm
subwoofer frequency range	30-120 Hz

Power

power supply	200-240 V, 50/60 Hz
standby power consumption	< 1 W

Dimensions

center speaker dimensions	286 x 93 x 64 mm
subwoofer dimensions	195 x 460 x 340 mm
set dimensions	390 x 71 x 360 mm