Philips Magnavox FW 338C - Inserting Batteries into the Remote; Demonstration Mode

| CONTROLS
E Inserting batteries into the Remote
E. Control
e Insert the batteries (Type R03 or AAA) into the
remote control as shown in the battery compartment.
VILUME CONTROL
~ wt
<
“5
>
mis
Y
».
A
TY
í
N
;
"ap
Š
# w i ; < i J
<< fo) [mi > a) [om oa)
ee eee ZL À, w — È
se LEA Se Par K. PO “= t
e To avoid damage from possible battery leakage,
remove dead batteries or batteries that will not be
used
for
a
long
time.
For
replacement,
use
type
RO3
or
Important:
To
cancel
demonstration
mode
AAA
batteries.
Before
you
begin
operating
the
system,
complete
e
Press
and
hold
STOP
M
(on
the
system
only)
for
3
the
preparation
procedures.
seconds
to
stop
the
demonstration.
— The demonstration mode will be switched off
Demonstration mode permanently.
J
—
The
system
will
switch
to
standby
mode.
The
system
has
a
demonstration
mode
that
shows
the
various features offered by the system. Whenever the
system is switched on from the wall socket, the
demonstration mode will start automatically.
Note:
— During demonstration mode, if you press any source
(or standby-on] button, the system will switch to the
respective for standby) mode.
— When the system is switched to standby mode, 5
seconds later, the demonstration mode will resume.
14