Philips Magnavox FW 338C - Tuning to Preset Radio Stations

L. 一 一
E
gsubuz
20
TUNER
Manual programming
1
2
3
Press TUNER.
Press TUNER (BAND) to select the desired waveband
:FM or AM.
Press PROGRAM for less than one second.
— PROGRAM flag, the frequency and preset number
start flashing.
— The next available preset number will be displayed
for selection.
Press TUNING << or >> to tune to the desired
frequency.
If yau wish to store the radio station to another preset
number, press PRESET W or A to select the desired
preset number.
Press PROGRAM again.
— PROGRAM flag will stop flashing, and the radio
station will be stored.
Repeat the above procedure to store other preset radio
stations.
Notes:
— When 40 radio stations are stored and you attempt to
store another radio station, the display will show
“PROGRAM FULL ”. If you want to change an
existing preset number; repeat steps 4 and 5.
— You can cancel manual programming by pressing
STOP M on the system only
— During programming, if no button is pressed within 20
seconds, the system will exit program mode
automatically.
Tuning to Preset Radio Stations
e Press PRESET Y or A to select the desired preset
number.
— The preset number, frequency and waveband
appear on the display
— — uv tm n nc 1,