Philips Magnavox FW 338C - General Information; Safety Information

--— x
' | r 1
ell = |____.
General Information... rcs 9
Safety Information ..................................................... 9
Praparation sm 10-11
Controls. 12-14
Operating The System .................................... 14-16
GO nn 16- 18
Iii 19-20
albania 21-22
AIIIN iraniens 22
CIOCK A paio 22
A N Di iraa 23
Recordini er 24-25
Maintenant O wi 26
Specifications seen 26
Troubleshooting ....................................................... 27
~
GENERAL INFORMATION
General Information
e The type plate (which contains the serial
number) is located at the rear of the system.
e Recording is permissible if copyright or other
rights of third parties are not infringed.
e This device complies with the FCC rules, part 15
and with 21 CFR 1040.10. Operation is subject to
the follovving two conditions:
— This device may not cause harmful
interference, and
— This device must accept any interference
received, including interference that may
cause undesired operation.
Environmental Information
All unnecessary packaging material has been omitted.
VVe have done our utmost to make the packaging easily
separable into three mono-materials: cardboard (box),
polystyrene foam (buffer) and polythene (bags, protective
foam sheet).
Your system consists of materials which can be recycled
and reused if disassembled by a specialized company.
Please observe the local regulations regarding the
disposal of packaging materials, exhausted batteries and
old equipment.
Accessories (Supplied)
— Remote control
— Batteries (2 x AAA size) for remote control
一 AM loop antenna
— FM antenna wire
— AC power cord
— 1 pair of surround speakers
Safe
SAFETY INFORMATION
Information
Before operating the system, check that the operating
voltage indicated on the typeplate (or the voltage
indication beside the voltage selector) of your system
is identical with the voltage of your local power
supply. If not, please consult your dealer. The type
plate is located at the rear of your system.
When the system is switched on, do not move it
around.
Place the system on a solid base (e.g. a cabinet).
Place the system in a location with adequate
ventilation to prevent internal heat build-up in your
system.
Do not expose the system to excessive moisture, rain,
sand or heat sources.
Under no circumstances should you repair the system
yourself, as this will invalidate the warranty?
If the system is brought directly from a cold to a warm
location, or is placed in a very damp room, moisture
may condense on the lens of the CD unit inside the
system. Should this occur, the CD player will not
operate normally. Leave the power on for about one
hour with no disc in the system until normal playback
is possible.
Electrostatic discharge may cause unexpected
problems. See whether these problems disappear if
you unplug the AC power cord and plug it in again
after a few seconds.
To disconnect the system from the power supply
completely, remove the AC power plug from the
wall socket.