Philips Magnavox FW 338C - Storing Preset Stations; Tuning to Radio Stations

De
al
KAN dë TIJA À
(nose | (6 pes )
ce, —
/ 12 , ) ( E E D
Na 4 t `
AAA e
ESTA SOU DO NTOL
cut CO2 cog BAND
Easy Set
EASY SET allows you to store all available radio stations
in a particular band (FM or AM) automatically.
e Press and hold STANDBYSON fon the system only)
for 2 seconds: when the system is in standby or
demonstration mode.
= “EASY SET” will be displayed and followed by
"TUNER".
— EASY SET will start with the last active band.
— All available radio stations with sufficient signal
strength will be stored or until 40 presets are filled.
Notes :
— When EASY SET is used, all previously stored radio
stations vvill be erased.
— The last preset radio station will appear on the display
when EASY SET is completed.
MINI HIFI SYSTEM
(e G =)
CI
VA
TAPE NA TAPE ZX
Pa TË
Tuning to radio stations
1 Press TUNER to select TUNER mode.
— "TUNER” will be displayed.
A few seconds later, the current frequency or the
radio station name if available will be displayed.
2 Press TUNER (BAND) again to select the desired
waveband : FM or AM.
3 Press TUNING << or >> for more than one second,
then release.
— The display will show "SERRCH" until a radio
station with sufficient signal strength is found.
e Repeat this procedure until the desired station is
reached.
e To tune to a weak station, briefly press TUNING <<
or >> until the display shows the desired frequency
and/or when the best reception has been obtained.
Storing Preset Stations
English
You can store up to 40 radio stations in the memory.
When a preset radio station is selected, the preset
number appears next to the frequency on the display.
Automatic programming
1 Press TUNER.
2 Press TUNER (BAND) again to select the desired
waveband : FM or AM.
3 Press PROGRAM for more than one second.
— PROGRAM flag starts flashing and AUTO" will be
displayed.
— Every available station for the selected waveband
will be stored automatically. The frequency and
preset number will be displayed briefly.
— The system will stop searching when all the
available radio stations are stored or when the
memory for 40 preset radio stations is used,
— The system will remain tuned to the last stored
preset radio station.
Repeat the above procedure to store other preset radio
stations for the other waveband. Remember to select
the next available preset number before proceeding. If
not, some of the preset radio stations may be erased.
Notes:
— You can cancel the automatic programming by
pressing PROGRAM or STOP M on the system only.
— Ifyou want to reserve a section of preset numbers, for
example preset numbers 1 to 9, select preset 10
before starting automatic programming: now only the
preset numbers 10 to 40 will be programmed.
19