Need help?Do you have a question about the Philips MANT510 and is the answer not in the manual?
Connect the supplied coaxial cable to the antenna's rear port.
Connect the antenna's coaxial cable to your TV's input.
Connect the power transformer to the antenna and then to an AC outlet.
Position antenna facing the signal transmitter for best reception.
Adjust VHF dipoles: fully extended for channels 2-6, 1/3 shorter in 'V' for channels 7-13.
Extend FM dipoles to 30 inches and position vertically or horizontally.
Rotate or tilt the UHF loop towards the transmitter for optimal signal.
Switch between ANTENNA and CABLE sources; LED indicates CABLE mode.
Adjust gain slowly for the clearest picture, avoiding excessive levels.
Connect the supplied coaxial cable to the antenna's rear port.
Connect the antenna's coaxial cable to your TV's input.
Connect the power transformer to the antenna and then to an AC outlet.
Position antenna facing the signal transmitter for best reception.
Adjust VHF dipoles: fully extended for channels 2-6, 1/3 shorter in 'V' for channels 7-13.
Extend FM dipoles to 30 inches and position vertically or horizontally.
Rotate or tilt the UHF loop towards the transmitter for optimal signal.
Switch between ANTENNA and CABLE sources; LED indicates CABLE mode.
Adjust gain slowly for the clearest picture, avoiding excessive levels.
General| Type | Indoor TV Antenna |
|---|---|
| Frequency Range | 470-862 MHz |
| Reception Range | Up to 25 miles |
| Impedance | 75 Ohm |
| Amplification | Yes |
| Connector Type | F-connector |
| Compatibility | HDTV |
To Next Page
