Philips MCD290 - Radio Reception; Tuning to Radio Stations; Programming Radio Stations

27
English
Radio Reception
DISPLAY/ST
2
THEATHRE
Tuning to radio stations
1 Press SOURCE on the set or TUNER on the
remote repeatedly until the desired waveband
(FM or MW) is displayed.
2 Press and hold TUNING 22/33 and release
the button.
➜ The radio automatically tunes to a station
with sufficient reception.
3 Repeat step 2 if necessary until you find the
desired station.
● To tune to a weak station, press TUNING
22/33 briefly and repeatedly until you have
found optimal reception.
Programming radio stations
You can store up to a total of 20 radio stations
for each band in the memory.
Automatic programming
Press PROGRAM for more than three
seconds to activate programming.
➜ All available stations are programmed.
➜ AUTO is displayed and available stations are
programmed in order of waveband.
Manual programming
1 Tune to your desired station (refer to “Tuning to
radio stations”).
2 Press PROGRAM to activate programming.
➜ PROG flashes on the display.
3 Press PRESETí/ë to allocate a number
from 1 to 20 to this station.
4 Press PROGRAM again to confirm the setting.
➜ PROG disappears.
5 Repeat the above four steps to store other
stations.
● You can override a preset station by storing
another frequency in its place.
Tuning to preset radio stations
● Press PRESETí/ë until the desired preset
station is displayed.
pg001-pg036_MCD290_98-Eng 2005.11.14, 14:5027