Philips MCM390/22 - Preparation for Recording; Synchro Start CD Recording; One Touch Recording; Recording Timer

17
English
Ta pe Operation / Recording
Preparation for recording
1 Select TAPE source.
2 Load a recordable tape into tape deck with full
spool to the left.
3 Prepare the source to be recorded.
CD – load the disc.
TUNER – tune to the desired radio station.
AUX – connect external equipment.
When recording is in progress
➜
REC is shown.
● To stop recording, press 9.
● It is not possible to listen to another source.
● It is not possible to activate the timer function.
Synchro start CD recording
1 Select CD source.
● Press S or T (¡ or ™) to select the
desired track to start recording.
● You can programme the tracks in the order you
want them to be recorded (refer to “CD/MP3-
CD Operations - Programming the disc tracks”).
2 Press RECORD to start recording.
➜ Playing of the CD programme starts
automatically from the beginning of the CD. It is
not necessary to start the CD player separately.
One touch recording
1 Select CD, TUNER or AUX source.
2 If necessary, start playback of the selected
source.
3 Press RECORD to start recording.
Recording timer
To record from the radio, you will need to use a
preset radio station and to set a start (ON) and
finish (OFF) time.
1 Select the preset radio station to record from
(refer to “Radio Reception - Tuning to preset
radio stations”).
2 In standby mode, press PRESET 3 for more
than two seconds.
➜ The current selected source is displayed.
3 Press SOURCE repeatedly until “REC TUN”
source is displayed.
4 Press PRESET 3 to confirm the source.
➜ “SET ON TIME” is displayed and the clock
digits for the hours flash.
5 Adjust VOLUME on the front pannel to set the
hours.
6 Press PRESET 3 again.
➜ The clock digits for the minutes flash.
7 Adjust VOLUME on the front pannel to set the
minutes.
8 Press PRESET 3 to confirm the recording start
time.
➜ “SET OFF TIME” is displayed and the clock
digits for the hours flash.
9 Repeat steps 5-7 to set the finish time.
0 Press PRESET 3 to confirm the timer settings.
➜ is shown and the recording timer is now
set.
Note:
– The recording timer will not be activated if the
system is in tape play mode.
pg 001-021_M390_22-Eng 2/2/05, 13:1117