13
Prepare the remote control
Caution
Risk of explosion! Keep batteries away from heat,
sunshine or fi re. Never discard batteries in fi re.
•
1 Open the battery compartment.
2 Insert 2 AAA batteries with correct
polarity (+/-) as indicated.
3 Close the battery compartment.
Note
Before pressing any function button on the remote
control, fi rst select the correct source with the remote
control instead of the main unit.
If you are not going to use the remote control for a
long time, remove the battery.
•
•
Set clock
1
In the standby mode, press and hold
CLOCK to activate the clock setting
mode.
The hour digits are displayed and begin
to blink.
If the hour digits are not displayed,
press and hold
for more than 2
seconds to switch to standby mode,
then repeat step 1.
2 Press + VOL - to set the hour.
The minute digits are displayed and
begin to blink.
3 Press + VOL - to set the minute.
4 Press CLOCK to confi rm the clock setting.
Turn on
1
Press .
»
»
»
Connect FM antenna
Tip
For optimal reception, fully extend and adjust the
position of the antenna.
For better FM stereo reception, connect an outdoor
FM antenna to the FM ANTENNA jack.
The audio system does not support MW radio
reception.
•
•
•
1 Connect the supplied FM antenna to the
FM ANTENNA jack on the main unit.
Connect power
Caution
Risk of product damage! Ensure that the power supply
voltage corresponds to the voltage printed on the back
or the underside of the audio system.
Risk of electric shock! When you unplug the AC power
cord, always pull the plug from the socket. Never pull
the cord.
Before connecting the AC power cord, ensure you have
completed all other connections.
•
•
•
1 Connect the power cord to the wall outlet.
English
EN
To Next Page
Loading...
