Philips MDV560VR - Steps to Upgrade DVD Player

6. Steps to upgrade MDV560VR/17
1. Burn the files to blank CD R or CDRW, using the following settings :
· File System CD-ROM ISO Level 2
· Mode 1/2/XA
· Character set ISO 9660
· Finalised, single session
· Write speed slow (e.g. 2x, 4x)
Finalize the disc. (The application may do this automatically.)
NOTE : Packet writing application for drag & drop copying cannot be used
for creating an upgrade disc. Use only a dedicated CD writing application
allowing ‘disc at once’ recording.
No UDF setting as well.
2. Power up the set.
3. Insert the CD that contain “lgtest.img” file to DVD player
4. Wait for a few minutes until you find the message Firmware Upgrade :
“Cancel” and “Start” on your TV screen. Move the cursor to Start and
press OK button on your remote control. Then the firmware starts and wait
for a few minutes.
5. When the door tray opened, take off the disc and wait for a few minutes and
don’t touch anything until product logo show on your TV screen.
6. Upgrade process is finished and you can enjoy your DVD player now.