Philips Mini IH - Page 5

5
EN
English
• If the power cord set
is damaged, it must
be replaced by a cord
set available from the
manufacturer.
• The appliance is not
intended to be operated
by means of an external
timer or a separate
remote-control system.
• Make sure to avoid
spillage on the power
connector to avoid a
potential hazard.
• Always follow the
instructions and use the
appliance properly to
avoid potential injury.
• Check if the voltage
indicated on the
appliance corresponds to
the local power voltage
before you connect it.
• According to the
instructions prescribed in
this user manual, use a
soft damp cloth to clean
the surfaces in contact
with food and make sure
to remove all the food
residues stuck to the
appliance.
• Do not let the power cord
hang over the edge of the
table or worktop on which
the multi-cooker stands.
• Only connect the
appliance to a grounded
power outlet. Always
make sure that the plug
is inserted rmly into the
power outlet.
• Do not use the appliance
if the plug, the mains cord
or the appliance itself
damaged.
• Make sure the heating
element, the temperature
sensor, and the outside
of the inner pot are clean
and dry before you put the
plug in the power outlet.
• Do not plug in the
appliance or press any of
the buttons on the control
panel with wet hands.
• Do not plug in the
appliance or press any of
the buttons on the control
panel with wet hands.
Caution
• CAUTION: Surface of the
heating element is subject
to residual heat after use.
• Never use any accessories
or parts from other
manufacturers or
that Philips does not