35
English
IMPORTANT!
– Make sure the FM and MW antennas
are connected.
– The TUNING button on the front
panel is used to toggle between
frequency tuning and preset tuning.
When in preset tuning mode, pressing
S / T buttons on the front panel
will change the preset number.
Otherwise, pressing S / T will
change the radio frequency.
Tuning to radio stations
1 Press TUNER on the remote (or adjust
SOURCE control on front panel) to select
“FM TUNER” or “MW TUNER”.
2 Press and hold S / T on the remote
until the frequency indication starts to change,
then release.
➜ The next radio station will tune
automatically.
➜ lights up for FM stereo reception.
3 To tune a weak station, press S / T
briefly and repeatedly until an optimal
reception is found.
● If you use S / T on the front panel for
frequency tuning, make sure the system is in
frequency tuning mode. If not, press
TUNING.
➜ "FREQ MODE" appears.
Presetting radio stations
You can store up to 40 preset radio stations in
the memory, starting from FM and followed by
MW bands.
Notes:
– The system will exit presetting mode if no
button is pressed within 20 seconds.
– If no stereo frequency is detected during Plug
and Play, "CHECK ANTENNA" appears.
Using the Plug and Play
Plug and Play allows you to store all available
radio stations automatically.
1 Connect the system to the power supply,
"AUTO INSTALL - PRESS PLAY"
appears.
OR
In Eco Power standby/standby mode,
press and hold ÉÅ on the front panel until
"AUTO INSTALL - PRESS PLAY"
appears.
2 Press ÉÅ on the front panel to start
installation.
➜ "INSTALL TUNER" appears.
➜ All previously stored radio stations will be
replaced.
➜ Once completed, the last tuned radio
station will play.
Tuner Operations
To Next Page
Loading...
