14
English
3139 115 21511
Switching the system on
In standby/demonstration mode
● Press STANDBY ON to switch on the last
selected source.
● Press 3 CDC, TUNER, TAPE or CDR/AUX.
● Press OPEN•CLOSE or DISC 1/2/3.
➜ The system will switch to CD mode.
Switching the system to standby
mode
In demonstration mode
● Press and hold STOP on the system.
In any other source mode
● Press STANDBY ON (or B on the remote
control).
➜ The clock will appear on the display when the
system is in standby mode.
Dim mode
You can select the desired brightness for the
display.
● Press DIM repeatedly to select DIM 1, DIM 2,
DIM 3 or DIM OFF display mode.
➜ DIM is shown, except for DIM OFF mode.
DIM
mode
1
2
3
OFF
Brightness
normal
half
half
normal
Spectrum
Analyser
off
on
off
on
Note:
– In tape mode, press DIM for more than two
seconds will reset the tape counter number to zero.
Volume control
Adjust VOLUME to increase (turn knob
clockwise or press VOLUME +) or decrease
(turn knob anti-clockwise or press VOLUME -)
the sound level.
To listen through the headphones
● Connect the headphones plug to
the n socket at the front of the
system.
➜ The speakers will be muted.
To switch off the volume temporarily
● Press MUTE on the remote control.
➜ Playback will continue without sound and
"MUTE" is displayed.
● To restore the volume, press MUTE again or
increase the volume level.
To adjust the speakers sound level
● Press BALANCE L or BALANCE R on the
remote control repeatedly to select the sound
level for left or right speaker respectively.
➜ "LEFT X", "RIGHT X" or "BALANCED
X" is displayed, "X" denotes the sound level.
Sound control
INCREDIBLE SURROUND
The Incredible Surround magnifies the virtual
distance between the front speakers for an
incredibly wide, enveloping, stereo effect.
● Press INCREDIBLE SURROUND (INC.
SURR.).
➜ If activated, INCREDIBLE SURROUND is shown
and “INCREDIBLE SURROUND ON” is
displayed.
➜ If deactivated, “INCREDIBLE
SURROUND OFF” is displayed.
Basic Functions
pg 001-030_MZ9_22-Eng 1/23/02, 1:59 PM14
To Next Page
Loading...
