6 Turn appliance OFF.
7 Clean the Bodygroom attachment after each
use (see ‘Cleaning’).
Grooming
1 Place the bodygroom attachment on the
appliance.
2 Turn the appliance ON.
3 Move the appliance against the direction of hair
growth.
4 Make sure the bodygroomer is always in full
contact with the skin.
5 Groom desired body parts below the neckline.
6 Turn appliance OFF.
7 Clean the bodygroom attachment after each
use (see ‘Cleaning’).
Trimming and Grooming Tips
- For best trimming results, skin and hair should be
clean and dry.
- For best body grooming results, use in the shower
or bath. Apply shaving cream or gel to skin for
easy gliding.
- Do not move the appliance too fast. Make
smooth and gentle movements.
- Do not press too hard. Pressing too hard may
cause skin irritation.
- Stretching your skin with your free hand makes
the hairs stand upright and can help prevent skin
irritation.
English
18
clEaning
- Do not use abrasive cleaning agents, scourers or
aggressive liquids such as gasoline to clean the
appliance and attachments.
- Be careful with hot water. Always test water rst
so as not to burn or scald hands.
- While rinsing the appliance, water may drip out of
the base of the appliance. This is normal. Simply
hold appliance upright for 10-15 seconds.
Cleaning the Shaving Unit
1 Rinse the shaving unit under hot water for a
couple of minutes.
2 Press the shaving unit release buttons (1) and
pull shaving unit off the shaving attachment (2).
3 Rinse the shaving unit for 30 seconds under
hot water.
4 Carefully shake off excess water and let the
shaving unit air dry thoroughly.
Never dry the shaving unit with a towel or tissue
as damage may occur to the shaving heads.
5 Reattach the shaving unit to the shaving
attachment.
Note: You can also clean the shaving attachment
and shaving unit with the supplied brush.
English
19
To Next Page
Loading...
Need help?
General
