Using Beard Styler without the Comb
- Use the beard styler attachment without the
comb to contour or cut shapes in your beard hair.
1 Remove the Beard Styler comb.
2 Turn appliance ON.
3 Contour your beard as desired.
Be careful, the styler cuts hairs very close to the
skin, at a length of 3/64 in./1mm.
4 Turn appliance OFF.
5 Clean Beard Styler after each use (see
‘Cleaning’).
Body grooming
- Only use the Bodygroom attachment to groom or
trim body hair below the neckline. Do not use it
to shave or trim facial or scalp hair.
Note: Before using, check foil, cutters, trimmers
and combs for wear or damage. If they show
signs of wear or damage, do not use. Replace
immediately (see section ‘Replacing the Bodygroom
Foil’)
1 Pull the shaving attachment straight off the
appliance. Do not twist.
English
16
2 Attach the Bodygroom attachment. Press down
rmly.
Trimming with the trimming comb
- The comb size (1,2 or 3) is indicated on the back
of the comb.
- The comb size corresponds to the remaining
hair length after trimming: comb 1 (1/8 in./3mm),
comb 2 (3/16 in./5mm), comb 3 (9/32 in./7mm).
Note: If hair is longer than 13/32 in./ 10mm, trim
rst with comb 1 (1/8 in./3mm) to make grooming
easier.
1 Snap the desired comb onto the appliance
making sure the teeth of the comb point in the
direction you will move the appliance.
- When you move the appliance towards you, the
teeth must point towards you.
- When you move the appliance away from you,
the teeth must point away from you.
2 Turn the appliance ON.
3 Move the appliance against the direction of hair
growth.
4 Make sure the at part of the trimming comb
is always in full contact with the skin.
5 Trim desired hair below the neckline.
English
17
To Next Page
Loading...
Need help?
General
