4 Shake off excess water and allow to air dry
thoroughly.
5 Place bodygroom foil back on the attachment.
Cleaning the Beard Styler Attachment
1 Remove the beard styler comb.
2 Rinse the beard styler attachment and comb
under hot water.
3 Shake off excess water and allow to air dry
thoroughly.
Tip: Lubricate the trimmer teeth with one drop
of mineral oil every 6 months.
This shaver has no other user-serviceable parts.
For assistance call 1-800-243-3050.
rEplacing thE shaving unit razor hEads
- Replace the Shaving Unit razor heads every 12
months for optimal results.
- Replace with SH30 Philips Norelco razor heads
only
1 Follow steps 1-4 under ‘Extra-thorough
Cleaning Method’ section.
English
22
2 Remove the shaving heads and place new ones
in the shaving head holder making sure the two
wings of the shaving heads t exactly into the
recesses.
3 Reattach the retaining ring (1) by turning it
the opposite direction of the arrows on the
retaining ring (2).
Make sure the four wings of the retaining ring
are located exactly under the recesses of the
shaving head holder.
4 Reattach the shaving unit to the shaving
attachment. If it does not close smoothly, check
that the shaving heads and retaining rings are
positioned properly.
rEplacing thE Bodygroom foil
- Replace the Bodygroom foil every 12 months for
optimal results.
- Replace with BG2000 Philips Norelco Bodygroom
Replacement foil.
1 Pull the bodygroom foil off the attachment.
2 Place the new foil on the attachment and snap
into place.
The foil is a precision part. Handle with care.
English
23
1
2
To Next Page
Loading...
Need help?
General
