Philips PDS-150e - Page 8

PDS-150e Product Guide8
Power Data Eth Tx Eth Rx Fault Output
Com Data 24V Com Data 24V Com Data 24V Com Data 24V Com Data 24V Com Data 24V
DMX OUT REPEATER
DMX
LOOP OUT
DMX IN
ETHERNET
Com D- D+ 24V Com
Aux Output
150W Power Supply
CAUTION: There is one fuse per two terminal blocks
denoted as Groups A, B, C,
Therefore, the maximum number of lights on
any one group must be limited per
PDS 150 Installation Instruction.
Group AGroup BGroup C
Output
DMX OUT REPEATER
DMX
LOOP OUT
DMX IN
ETHERNET
15
Group A
5
5
5
5
1
O
1
Ot t
1
Output
Output
Output
p
A
Terminator
Output
DMX OUT REPEATER
DMX
LOOP OUT
DMX IN
ETHERNET
15
Group A
5
5
5
5
1
O
1
Ot t
1
Output
Output
Output
p
A
Output
DMX OUT REPEATER
DMX
LOOP OUT
DMX IN
ETHERNET
15
Group A
5
5
5
5
1
O
1
Ot t
1
Output
Output
Output
p
A
Terminator
From
Controller
From
Controller
From
Controller
To next
PDS 150e
To another
PDS 150e
Every 32nd
PDS 150e in chain
D+
D-
GND
+24 VDC
Data +
Data -
GND
z
z
+24 VDC
Make Data Input Connections
PDS-150ehasdifferentconnectorsforDMXandEthernetdatainputs.
DMX Data Input Connections
1. RunCAT5eorbettercablefromthedataoutputportofaPhilipsColorKinetics
DMXcontroller,suchasiPlayer3,andconnectittotheDMXINport.
2.Toaddanotherpower/datasupplytotheDMXchain,runacablefromthe
device’sDMXLOOPOUTporttothenextdevice’sDMXINport.
3.After32devices,insertaDMXterminatorintheDMXLOOPOUTportand
insertacablefromtheDMXOUTREPEATERporttotheDMXINportofthe
nextpower/datasupply.(ThiswillboosttheDMXsignalandmaintaindata
integrity.)
4. Atthelastpower/datasupplyintheDMXchain,insertaDMXterminatorinthe
DMXLOOPOUTport.
Power Data Eth Tx Eth Rx Fault Output
Com Data 24V Com Data 24V Com Data 24V Com Data 24V Com Data 24V Com Data 24V
DMX OUT REPEATER
DMX
LOOP OUT
DMX IN
ETHERNET
Com D- D+ 24V Com
Aux Output
150W Power Supply
CAUTION: There is one fuse per two terminal blocks
denoted as Groups A, B, C,
Therefore, the maximum number of lights on
any one group must be limited per
PDS 150 Installation Instruction.
Group AGroup BGroup C
D+
D-
GND
+24 VDC
Data +
Data -
GND
z
z
+24 VDC
DMX
Input/Output
Ports
EthernetInput
Port
E The Aux Output allows you to connect
to third-party controllers, as well as to
older Philips Color Kinetics controllers. The
included 5-pin connector ts into this port,
which can supply power and receive data via
5-wire DMX cable.
E
If a total DMX run length exceeds
1000 ft (305 m), we recommend using a
commercially available third-party DMX
repeater.