English
locking
the rocker
switch
The rocker switch
CD
incorporates a transport locking
system which prevents the switch from being accidef'-
tally depressed, which action would result
in
unneces-
sary use of the battery. The switch is locked by pushing
the locking butten
@ down, and unlocked
by
pressing
the butten up.
lnserting the battery (Fig.
2)
• Slide off the battery compartment lid @.
• Remove the terminal strip from the compartment and
press it onto the poles of a 9 V battery, 6F22 or
PP
3
ty
pe
. The strip fits
in
one position only.
•
Push
the battery
l4
and the strip
as
illustrated into the
compartment; ensure that the strip in the compartment ·s
around the battery to facilitate its removal.
• Finally, refit the lid of the battery compartment.
Checking the battery voltage
For a correct working of the machine, it is necessa
r,
that the battery is
in
good condition. Therefore, it is re-
commended to check the battery voltage from lime to
lime, especially after intensive use of the machine.
T o do this, push the top of the rocker switch
CD
inwards
and pull control
® downwards.
If
the battery voltage is
still sufficient, a buzzing sound will
be
audible.
If
this is
not the case, the battery must
be
replaced.
If the battery
is
exhausted
or
if the machine is not to be
used for a longer period, remove the battery
in
order to
prevent damage due to possible battery leakage.
4
lnserting
and removing the
cassette
Each side of a
LFH
0002
cassette will play for
15
mins.
i.e. 30 mins.
in
total. For identification, one side of the
cassette is marked with one dot and the ether side with
two dots. When one side is full (the left-hand reel is then
empty), the cassette may
be
turned over to continue
on
the ether side.
N.B.
The cassette may
be
turned over
whenever desired, there is no need to wait until the end
of the tape is reached.
Since the cassette weighs only
11
grams, it can
be
mailed without difficulty
by
letter post.
lnserting the cassette
(Fig.
3)
• Hold the cassette compartment lid ® at the bottom
and slide the lid downwards until the initial stop.
• lnsert the cassette with the full reel
on
the left. Hold
it
by
its sides, press the open cassei,e front against the
pressure springs which are beneath the lid (A) and
gently push the cassette over the two spindles
(B).
• Close the lid.
Removing the cassette
• Open the cassette compartment lid ® until the initial
stop.
• Lift the cassette at the sides and take it out of the
cassette compartment.
• Close the lid.
5
To Next Page
Loading...
