Philips Q-Line 55BDL3010Q - Page 19

9
2.5.2. ID Remote Control
SetremotecontrolIDnumberwhenusingseveraldisplays.
Pressthe[ID]buttonandtheredLEDblinkstwice.
1. Pressthe[ID SET]buttonformorethan1secondtoentertheID
mode.TheredLEDlightsup.
Pressthe[ID SET]buttonagaintoexitfromtheIDmode.Thered
LEDlightsoff.
Pressthedigitnumbers[0]~[9]toselectthedisplaytobecontrolled.
Forexample:press[0]and[1]fordisplayNo.1,press[1]and[1]for
displayNo.11.
Theavailablenumbersare[01]~[255].
2. Ifnobuttonispressedwithin10seconds,itwillexitfromtheID
mode.
3. Ifawrongbuttonispressed,waitfor1seconduntiltheredLED
lightsoffandthenturnsonagain,thenpressthecorrectdigits.
4. Press[ENTER]buttontoconrmyourselection.TheredLEDblinks
twiceandthenlightsoff.
NOTE:
• Pressthe[NORMAL]button.ThegreenLEDblinkstwice,indicating
thatthedisplayisundernormaloperation.
• ItisnecessarytosetuptheIDnumberforeachdisplaybefore
selectingitsIDnumber.