Philips Q-Line 55BDL3010Q - Page 32

22
How to setup the settings in the menu to
control all the monitors at the same time and
individually via RC?
Daisy chained by RS232 and no IR cable 1.Therstdisplaysetsas“Primary”onOSD
(Advanced option/IR control item), others set as
“Secondary”.
2. The setup OSD will show on top left side of
the display. (Toggle MENU will show again if it
disappears)
3. Default setting: ID NO: 0, GP NO: 0, this setting
can control all displays by IR.
The“+”,“-”canchange“IDNO”tocontrol
signaldisplayby“MonitorID”.
The“UP”,“DOWN”canchange“GPNO”to
controlmulti-displayby“GroupID”.
*TherstdisplayisalwayscontrolledbyIR.
How does the RC work? Daisy chain : no connection of RS232 and IR
cable
No setting is required. Connect with IR cables
and control by IR.
*This may cause out-of-synchronizm
phenomenon. It is suggested to use the above
settings with RS-232 cable.