Philips Respironics Amara - Disassembly and Assembly of the Mask; Mask Components Disassembly; Mask Components Assembly; Tubing Quick Release

5
Disassembly of the Mask
1. Headgear - Remove from the forehead pad support and
headgear clips .
2. Forehead pad - Slide off the track of the forehead pad
support (Figure 7).
3. Mask Cushion - Grasp and pull it off the mask frame
(Figure 8).
Assembly of the Mask
1. Forehead pad - Slide on the track of the forehead pad
support.
2. Mask Cushion - Use your thumbs to press the cushion
past the retaining tabs on the elbow and press into place
(Figure 9).
3. Headgear - Thread the top straps through the forehead
pad support, and the bottom straps through the headgear
clips. Push the headgear clips onto the mask frame.
Tubing Quick Release
The elbow is equipped with a quick release swivel for the
CPAP tubing. Simply pull on the swivel with the tubing
attached and the tubing will release from the entrainment
elbow.
Figure 7
Figure 8
Figure 9