Philips respironics - System Features and Setup; System Features and Contents

3
System Features and Contents
IMPORTANT: Read and understand the entire manual for your therapy device before attempting to use this humidifier.
Humidifier Door
Air Inlet Port
Air Outlet Port
Humidifier
(connects to Therapy Device)
Heater Plate
Water Tank
Maximum Fill Lines
This figure illustrates many of the device features and contents, described in the table below.
ITEM DESCRIPTION
Humidifier Connect your therapy device here.
Air Inlet Port Connects to the outlet port on the therapy device.
Air Outlet Port
(conical, 22 mm)
Connect the patient circuit here.
Heater Plate Warms the water in the water tank.
Humidifier Door Open the door to access the water tank.
Humidifier Door Lever Lift up on the lever to open the humidifier door.
Water Tank The removable water tank holds the water for humidification.
Maximum Fill Lines The fill lines indicates the maximum water level for safe operation. (Found on front and both sides of tank)
Note: Read all instructions before using the humidifier.
Note: This humidifier is specified for use with Respironics REMstar and BiPAP therapy devices only.