EN4
3 Get started
Always follow the instructions in this chapter in
sequence.
Charge the built-in battery
The speaker is powered by a built-in
rechargeable battery.
Note
• Fully charge the built-in battery before using.
• When the speaker is turned on and the battery
is low, the battery level LED indicator blinks
green.
Connect the USB-C socket on the speaker to
an outlet (5V 3A) by using the provided USB
cable.
5V
3 A
When the speaker is being charged,
the battery level LED indicator lights up
gradually.
When the speaker is fully charged, the
battery level LED indicator lights on.
Caution
• Risk of speaker damage! Make sure the power
supply voltage corresponds to the voltage
printed on the back or the underside of the
speaker.
• Risk of electric shock! When unplug the USB
cable, always pull the plug from the socket.
Never pull the cable.
• Use only a USB cable specified by the
manufacturer or sold with this speaker.
Turn on/o
Press to turn the speaker on.
You will hear the prompt sound.
If no external audio device is connected
to the AUX socket, it will enter
Bluetooth pairing mode automatically
and the LED indicator will blink blue.
To turn the speaker o, press again.
Note
• The speaker will turn o automatically after
15minutes without audio signal from Bluetooth
or via AUX IN.
To Next Page
Loading...
