Need help?Do you have a question about the Philips SPA20 and is the answer not in the manual?
General| Housing material | - |
|---|---|
| Recommended usage | PC |
| Suitable for outdoor use | No |
| Number of drivers | 2 |
| Speaker placement | Tabletop/bookshelf |
| Audio output channels | 2.0 channels |
| Subwoofer driver diameter (imperial) | 2.5 \ |
| Amplifier class | A/B |
| Impedance | 10 Ω |
| Frequency range | 20 - 20000 Hz |
| RMS rated power | 3 W |
| Signal-to-Noise Ratio (SNR) | 75 dB |
| Total Harmonic Distortion (THD) | 1 % |
| Cable length | 1.5 m |
| Channel separation | 45 dB |
| Quick installation guide | Yes |
| Connectivity technology | Wired |
| AC input voltage | 220 V |
| Power source type | USB, AC |
| AC input frequency | 50 Hz |
Weight and Dimensions| Depth | 80 mm |
|---|---|
| Width | 158 mm |
| Height | 121 mm |
| Weight | 601 g |
Follow all instructions. Avoid liquid exposure, naked flames, and direct heat. Use only manufacturer-specified accessories.
Product complies with EU radio interference. Recyclable materials used. Proper disposal according to local regulations is advised.
Register your product at www.philips.com/welcome for full support benefits. Model and serial numbers are required for assistance.
Insert USB plug into PC's USB socket and audio plug into headphone jack. Adjust PC volume. Disconnect after use.
Details USB power input, dimensions, weight, and operating system requirements for PC and Mac.
Check speaker connection and PC volume. Do not attempt to repair the system yourself.
To Next Page
