Philips S9311 - Step 1: Connect System Power; Step 2: Open System Top Cap; Step 3: Place System on Level Surface; Step 4: Shake Excess Water from Shaver

ENGLISH
may not work properly. Charge the shaver
in the
SmartClean System before using the
SmartClean System to clean your shaver.
◗ If you use the shaver with shaving foam or gel,
quickly rinse under hot water before cleaning
in the SmartClean System.
1 Connect the small plug to the SmartClean
System
. Connect the power plug into any
100V to 240V AC outlet. Use only the
power cord provided.
C 2 Press the top cap to open the SmartClean
System.
3 Place the SmartClean System on a flat,
level surface. Make sure the seal has been
removed from the cleaning cartridge (see
‘Preparing SmartClean System For Use’).
C 4 Shake off any excess water from shaver
before placing in the SmartClean System.
C 5 Hold the shaver head side down above the
shaver holder.
28
14_S9531_S9311.indd 28 12/15/14 2:41 PM