Philips S9311 - Step 6: Connect Shaver to Holder; Step 7: Charging Status Indicator; Step 8: Initiate Cleaning Cycle; Step 9: Cleaning Cycle Indicator

ENGLISH
C 6 Place the shaver into the holder (1), push
shaver back (2) and press down the top
cap to connect the shaver (3) (click).
The shaver will only fit in the SmartClean System
in one direction.
7 The battery symbol slowly blinks to
indicate shaver is charging.
8 Press the ON/OFF button on the
SmartClean System to start the cleaning
cycle.
C 9 The cleaning symbol will blink.
◗ The cleaning cycle takes approximately 10
minutes.
C ◗ During the drying phase, the drying symbol
will blink.
◗ The drying phase takes approximately 4 hours.
◗ Do not press the ON/OFF button while the
cleaning cycle is running. If this does occur,
the cleaning cycle will stop and the cleaning or
drying symbol stops blinking. The cleaning cycle
can be re-started by pressing the ON/OFF
button once.
◗ If the power plug is disconnected before the
cleaning cycle is complete, reconnect the plug
into the outlet and the cleaning cycle can be
re-started by pressing the ON/OFF button
once.
29
±4 hrs.
3
1
2
14_S9531_S9311.indd 29 12/15/14 2:41 PM