Philips S9987/59 - Cleaning the Click-On Attachments

English
62
Cleaning the click-on attachments
Never dry the trimmer or beard styler attachments
with a towel or tissue, as this may damage the
trimming teeth.
The accessories supplied may vary for dierent
products. The box shows the accessories that have
been supplied with your product.
Cleaning the beard styler attachment
Clean the beard styler attachment after each use.
1 Pull the comb o the beard styler attachment.
Note: Grab the comb in the center to pull it o the
beard styler attachment. Do not pull at the sides
of the comb.
2 Rinse the cut hairs o the cutting unit with
lukewarm water.
3 Rinse the cut hairs o the comb.
4 Remove the cutting unit from the beard styler
attachment. By pushing the cutting unit from the
beard styler attachment you can remove any hairs
that have accumulated inside the beard styler. You
can also rinse the back of the cutting unit.
5 Rinse cut hairs out of the beard styler attachment.
6 Carefully shake o excess water and leave the
comb, cutting unit and beard styler attachment to
air-dry before next use.
Never dry the cutting unit with a towel or
tissue, as this may damage the trimming teeth.