Philips SDV8622T User Manual

24
Properly sealed against leaks at the •
installation site.
Do not install your antenna on a wet or •
windy day.
If the assembly starts to drop, get away •
from it immediately. Remember: the
antenna, mast, cable, and metal guy wires
are all excellent conductors of electrical
current. Even the slightest touch of any
of these parts to a power line can cause
electrocution and death.
If any part of the antenna system should •
come in contact with a power line, don’t
touch it or try to remove it yourself. Call
your local power company. They will
remove it safely.
If an accident occurs with the power •
lines, call for qualied emergency help
immediately.
Notice for USA
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy
and, if not installed and used in accordance
with the instruction manual, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged
to try to correct the interference by one or
more of the following measures:
Relocate the receiving antenna.•
Increase the separation between •
equipment and receiver.
1 Important
Safety
This manual contains important information
about the Philips indoor/outdoor television
antenna. Read it carefully before you start the
installation and setup.
For indoor use
The product shall not be exposed to •
dripping or splashing and no objects lled
with liquid, such as vases, shall be placed
on the product.
To completely disconnect the power •
input, the main plug of the product shall
be disconnected from the main AC
outlet.
Where the main plug is used as the •
disconnect device, the disconnect device
shall remain readily operable.
No naked ame sources, such as lighted •
candles, should be placed on the product.
For outdoor use
If this is the rst time you install an •
antenna, for your own safety as well as
others, seek professional assistance.
Perform as many functions as possible on •
the ground.
Select your installation site carefully. •
Remember: electric power lines and
phone lines look alike. For your safety,
assume that all overhead lines may cause
fatal injury.
Ensure that the installation site is •
structurally capable to support all loads
(weight of the antenna, weight of ice,
weight of snow and wind force).
EN
DFU_SDV8622T_55_Book.indb 24 2011-6-23 14:42:21

Philips SDV8622T Specifications

General

Dimensions (WxDxH)	7.6 x 1.6 x 10 mm
Antenna cable length	60 m
Packaging tare weight	0.361 kg
Quantity outer carton	1 pc(s)
Supported radio bands	UHF, VHF
Width (cm) outer carton	13.8 cm
Height (cm) outer carton	32 cm
Length (cm) outer carton	24.5 cm
Tare weight outer carton	0.59 kg
Net weight (outer carton)	1.808 lbs
Net weight of outer carton	0.82 kg
Gross weight (outer carton)	3.109 lbs
Gross weight of outer carton	1.41 kg
Package depth	12.6 mm
Package width	230 mm
Package height	330 mm
Package weight	1.181 kg
AC adapter included	Yes

Weight and Dimensions

Depth	40 mm
Width	19.3 mm
Height	25.5 mm
Weight	0.285 g
Depth (imperial)	5 \
Width (imperial)	9.1 \
Height (imperial)	13 \
Tare weight (imperial)	0.796 lbs
Gross weight (imperial)	2.604 lbs
Width outer carton (imperial)	5.4 \
Height outer carton (imperial)	12.6 \
Length outer carton (imperial)	9.6 \
Tare weight outer carton (imperial)	1.301 lbs