Philips SpeechMike Pro PLUS LFH 5276 - SpeechMike Installation; System Requirements; Hardware Installation (Windows 2000;XP)

- 8 / 26-
Description
1 Ring plastic
2 Track ball
3 Slider knob
4 Upper housing
5 Speaker
6 Upper key set
7 Light conductor
8 Microphone grill
9 Scroll wheel
10 Microphone
11 Carrier unit
12 Ring magnetic
13 Cushion
14 Slide switch
15 Prism
16 P.C.B 1
17 P.C.B 2
18 Lower key set
19 Lower housing
20 USB cable
6 SpeechMike installation
6.1 System requirements
•IBM-compatible PC with Pentium II, 233MHz processor (Pentium III, 500MHz
recommended)
•At least 64 MB RAM (128 MB recommended)
•75 MB hard disk space for SpeechMike drivers & software
•A self-powered USB port with 300mA of output power (see the Troubleshooting section for
details)
•Windows 98 SE*, Windows Me*, Windows 2000 or Windows XP. It is highly recommended
that you have the latest Service Packs installed for your operating system.
* Note: Windows 98 SE and Windows Me operating systems are supported for driver installation only!
6.2 Hardware installation Windows 2000 and Windows XP:
A)Turn on your computer and plug the SpeechMike device into the USB port.
B) The New Hardware Found message will be displayed on your screen shortly.
Note: If this message does not appear, verify whether the USB port is enabled in the BIOS of your system. See
your hardware documentation for details or contact your hardware vendor.
C) Installation will proceed automatically.