Note
Note
After powering on, if the earpieces cannot nd
any previously connected Bluetooth device, it
will automatically switch to pairing mode.
The earpieces stores 1 device in the memory. If
you try to pair more than 2 devices, the earliest
paired device is replaced by the new one.
Pair the earpieces with
another Bluetooth device
The earpiecess are now in
pairing mode and is ready to
pair with a Bluetooth device
(e.g. a mobile phone)
Turn on the Bluetooth function
of your Bluetooth device, select
Philips TAA7306.
Enter the earpieces password
“0000” (4 zeros) if prompted.
For those Bluetooth devices
featuring Bluetooth 3.0 or higher,
no need to enter a password.
Turn on the Bluetooth function of
your Bluetooth device.
Pair the earpiecess with your
Bluetooth device. Refer to the user
manual of your Bluetooth device.
The following example shows you
how to pair the earpieces with
your Bluetooth device.
If you have another Bluetooth device
that you want to pair with the earpieces,
make sure the Bluetooth function in any
other previously paired or connected
devices are turned o. Then follow the
steps in ‘Pair the earpieces with your
Bluetooth device at the rst time’.
Philips TAA7306
UV sterilization function
Put the earpieces into charging case
and close the lid, the UV sterilization
LED will turn on for 1 minute.
To Next Page
Loading...
