Philips TAB5706 - Placement

English
9
Replace the Remote Control
Battery
1 Press and slide the back cover to
open the battery compartment of
the remote control.
2 Insert two AAA size batteries
(included). Make sure the (+) and
(–) ends of the batteries match the
(+) and (–) ends indicated in the
battery compartment.
3 Close the battery compartment cover.
Precautions Concerning
Batteries
• Be sure to insert the batteries with
correct positive " " and negative
" " polarities.
• Use batteries of the same type.
Never use different types of
batteries together.
• Either rechargeable or non-
rechargeable batteries can be used.
Refer to the precautions on their
labels.
• Be aware of your fingernails when
removing the battery cover and the
battery.
• Do not drop the remote control.
• Do not allow anything to impact the
remote control.
• Do not spill water or any liquid on
the remote control.
• Do not place the remote control on
a wet object.
• Do not place the remote control
under direct sunlight or near sources
of excessive heat.
• Remove the battery from the
remote control when not in use for
a long period of time, as corrosion
or battery leakage may occur and
result in physical injury, and/or
property damage, and/or fire.
• Do not use any batteries other than
those specified.
• Do not mix new batteries with old
ones.
• Never recharge a battery unless it
is confirmed to be a rechargeable
type.
Placement
For best results, place your Soundbar as
shown below.