3 Get started
Charge the battery
Note
Before you use your headphones for the rst
time, charge the battery for 2hours for
optimum battery capacity and lifetime.
Use only the original USB charging cable to
avoid any damage.
Finish your call before charging the
headphones, as connecting the headphones
for charging will power the headphones o.
Connect the supplied USB charging
cable to the charging slot on the
headphones and the charger/USB port
of a computer.
LED turns white during charging and
turns o when the headphones is fully
charged.
Tip
Normally, a full charge takes 2 hours.
Tip
Enter the headset password "0000" (4 zeros) if
prompted. For those mobile phones featuring
Bluetooth 3.0 or higher, no need to enter a
password
Pair the headphones
with your mobile phone
Make sure that the headphones are
fully charged and turned o.
Before you use the headphones with
your mobile phone for the rst time, pair
it with a mobile phone. A successful
pairing establishes a unique encrypted
link between the headphones and
mobile phone. The headphones store
the last 4 devices in the memory . If you
try to pair more than 4 devices , the
earliest pained device is replaced by the
new one.
Press and hold the on/o button
(>4s), blue and whites LED ashes
alternately which means the head-
phones enter Bluetooth pairing
mode. The headphones remain in
pairing mode for 5 minutes.
Make sure that the mobile phone is
turned on and its Bluetooth feature
is activated.
Pair the headphones with the
mobile phone. For detailed infor-
mation, refer to the user manual of
your mobile phone.
To Next Page
Loading...
