Philips TAT2159 - Reset the Earpieces; Technical Data

5 Reset the
earpieces
1
2
3
4
5
6
On your Bluetooth device, go to the
Bluetooth menu and remove Philips
TAT2159 from the device list.

your Bluetooth device.
Return earpieces to charging box
and open the lid.
Press
press both R & L MFT on the
earpieces for 10 seconds with both
earpieces inside and the box open.
Follow steps in “Use your earpieces-
connect the earpieces to your
Bluetooth device.”
Pair the earpieces with your
Bluetooth device, select Philips
TAT2159.
If you encounter any pairing or connection
issue, you can follow the following
procedure to reset your earpieces to
factory default settings.
If there is no response from the
earpieces, you can follow the below step
to reset the hardware of your earpieces.
Return earpieces to charging box and
open the lid, press the button on box
for more than 10 seconds.
6 Technical data
Music play time :
up to 14 hours (6 + 8)
Charging time: 2.5 hours
Lithium-ion battery 40 mAh on
each earpiece, Lithium-ion battery
190 mAh on charging box
Bluetooth version: 5.4

- 
- A2DP (Advanced Audio

- AVRCP (Audio Video

Supported audio codecs: SBC
Frequency range: 2.402-2.480 GHz
Transmitter power: < 10 dBm
Operating range: Up to 10 meters
(33 feet)

USB-C port for charging
Low battery warning: available
IPX4 splash and sweat resistant
 
notice.
Note
11 EN