Philips TAT2206WT/00 - Important Safety Instructions; Hearing Safety; General Information

1 Important
safety
instructions
Hearing Safety
Danger
 To avoid hearing damage, limit the time you
use headphones at high volume and set the
volume to a safe level. The louder the
volume, the shorter the safe listening time is.
Be sure to observe the following guide-
lines when using your earphones.
• Listen at reasonable volumes for
reasonable periods of time.
• Be careful not to adjust the volume
continuously upwards as your
hearing adapts.
• Do not turn up the volume so high
that you can't hear what's around
you.
• You should use caution or tempo-
rarily discontinue use in potentially
hazardous situations.
• Excessive sound pressure from
earphones and headphones can
cause hearing loss.
• Using headphones with both ears
covered while driving is not recom-
mended and may be illegal in some
areas while driving.
• For your safety, avoid distractions
from music or phone calls while in
trac or other potentially dangerous
environments.
General information
To avoid damage or malfunction:
Caution
 Do not expose headphones to excessive heat.
 Do not drop your headphones.
 Headphones shall not be exposed to dripping
, splashing water.
 Do not allow your headphones to be
submerged in water.
 Do not use any cleaning agents containing
alcohol, ammonia, benzene, or abrasives.
 If cleaning is required use a soft doth, if
necessary dampened with a minimum amount
of water or diluted mild soap, to clean the
product.
 The integrated battery shall not be exposed to
excessive heat such as sunshine, re or the
like.
 Danger of explosion if battery is incorrectly
replaced. Replace only with the same or
equivalent type.
• Disposal of a battery into re or a hot oven, or
mechanically crushing or cutting of a battery,
can result in an explosion;
• Leaving a battery in an extremely high
temperature surrounding environment can
result in an explosion or the leakage of
ammable liquid or gas;
• A battery subjected to extremely low air
pressure that may result in an explosion or the
leakage of ammable liquid or gas.
About operating and storage temperatures
and humidity
• Store in a place where temperature is
between -20°C (-4°F) and 50°C (122 °F)
(up to 90% relative humidity.
• Operate in a place where temperature
is between 0°C (32°F) and 45°C (113 °F)
(up to 90% relative humidity.
• Battery life may be shorter in high or
low temperature conditions.
• Replacement of a battery with an
incorrect type that can defeat a
safeguard (for example, in the case of
some lithium battery types);