Philips TAT8506 - Get Started; Charge the Battery

3 Get started
Charge the battery
Charging Box
Earpieces
• The earpieces start charging and the
blue LED light goes on
• When the earpieces are fully
charged, the blue light will go o
Place the earpieces in the charging box.
Plug one end of the USB-C cable into
the charging box and the other end into
the power source.
 Before you use your headphones, place them
in the charging box and charge the battery for
2 hours for optimum battery capacity and
lifetime.
 Use only the original USB-C charging cable to
avoid any damage.
 Finish your call before charging. Connecting
the earpieces to charge will power them o.
Note
 Normally, a full charge takes 2 hours (for the
earpieces or charging box) by USB cable.
Tip
 The charging box serves as a portable backup
battery for charging the earpieces. When the
charging box is fully charged, it will fully
recharge the earpieces 3 times.
Tip
Caution
Charging the battery with a wireless
charger.
• Place the earpieces in the charging
box
• Close the charging box cover
• Place the charging box on the center
of the wireless charger
• When fully charged, remove the
charging box from the wireless charger
 A full charge takes 4 hours by wireless charging.
Wireless charging
(Wireless charger is not included)
The charging box has a built-in wireless
charging coil. You can charge the battery
by using a wireless charger or another
device that functions as a wireless charger.
Precautions for wireless charging
 Do not place the charging box on the wireless
charger when conductive materials, such as
metal objects and magnets, are placed
between the charging box and the wireless
charger.
 Keep the charging box away from high
temperatures and water sources. The box may
get warm during charging. This is normal.
Tip
6 EN