Philips V40 107P5 - Bottom Tray Removal and Service Position

9 Go to cover page
9
Mechanical Instructions
V40 107P5
4. Main panel with Bottom Tray
-Remove 9 screws for disconnect the Bottom tray as Fig. 5.
-Pull the bottom tray from fig. 6 &
fig. 7.
Remove all screws between main board and bottom tray, then
transfer to service position.
on press right and left side clip
Reconnect connectors, some wires and panels (chassis),
service position can be available for DC/AC measurement
as shown in Fig. 8.
5. SERVICE POSITION
Fig. 6
Fig. 7
Fig. 5
Press CLIP
Screw
Press clip then Pull-up
=======>
Main panel
Video panel
Fig. 8 SERVICE POSITION
http://jdwxzlw.5d6d.com/?fromuser=华盛维修
家电维修资料网，免费下载各种维修资料