MAINTENANCE :
2
02.9663.0010 F 14-May-2009 19
WARNING: Backcap and adjustment knobs will be HOT during lamp operation.
Wear gloves and/or use tools to prevent burns.
To run tests:
Step 1. Press [Menu].
Step 2. Press [Up] / [Down] arrows until Test appears. Press [Enter].
Step 3. Use [Up] / [Down] arrows to select a parameter to test. Refer to table below
for a complete list of test parameters.
Step 4. Press [Enter] to run test.
Step 5. Press [Menu] to stop test at any time.
Table 2-1: Self Test Function Chart
1st Level 2nd Level 3rd Level 4th Level 5thLevel
Test
System Test
ALL Test All Motors RUN TEST Run-Test in Progress Press [Menu] to stop
tests
Pan/Tilt RUN TEST Run-Test in Progress
Dimmer (Arc Only) RUN TEST Run-Test in Progress
Blue RUN TEST Run-Test in Progress
Amber RUN TEST Run-Test in Progress
Magenta RUN TEST Run-Test in Progress
ColorMix Blue, Amber, Magenta test RUN TEST Run-Test in Progress
Diffusn Diffusion Test RUN TEST Run-Test in Progress
Rot Gobo Rotating Gobo Test RUN TEST Run-Test in Progress
Edge RUN TEST Run-Test in Progress
Zoom RUN TEST Run-Test in Progress
Beam (If Beam-Size Iris Accessory) RUN TEST Run-Test in Progress
Shutter (If Shutter Accessory) RUN TEST Run-Test in Progress
Rot Shut (If Shutter Accessory) RUN TEST Run-Test in Progress
Lamp Disables Pan/Tilt and executes
Home position.
RUN TEST Run-Test in Progress
Encoder Encoders Pan Pan Encoder XXXX Data
Tilt Tilt Encoder XXXX Data
Sensor Sensors Pan COT Sensor STST Sensor Test in
Progress
PASS/FAIL
Tilt COT Sensor
STST Sensor Test in
Progress
PASS/FAIL
Rot Gobo Gobo Select EOT
Sensor
STST Sensor Test in
Progress
PASS/FAIL
GoboIndx Gobo Index EOT
Sensor
STST Sensor Test in
Progress
PASS/FAIL
To Next Page
Loading...
