MAINTENANCE :
2
02.9663.0010 F 14-May-2009 25
Frame or Top Hat Replacement
An accessory frame holder is provided for the addition of a top hat or gel frame with
silks, frosts or color correction if required. The frame holder is designed to fit a
standard 7.5-inch gel frame or top hat.
To remove and replace frame or top hat:
Step 1. Disconnect luminaire AC input cable from power source.
Step 2. At front lens, press upward on accessory frame latch and turn to open.
Step 3. Remove frame/top hat, if any (Figure 2-6).
Step 4. Install frame/top hat and close latch.
Figure 2-6: Installing a Frame or Top Hat
Accessory Frame
Head Assembly
Latch
Press Up
and Turn
The accessory frame is not a Vari-Lite accessory.
NOTE:
Gel, Silk, or Frost
To Next Page
Loading...
