3. Get started
CAUTION
Before you connect your VoiceTracer, rst read
the safety instructions (see Safety instructions
[3]).
Charging the battery
• Charge the built-in battery before you use the device for
the rst time or if you haven’t used it for an extended time
period.
• If the battery is completely discharged and your device
turns o, allow the battery to charge for a while before
you turn on the device.
• A complete charging cycle takes about 3 hours.
• The device should be charged every 6 months even when
not used, to prevent the battery from completely draining
(deep discharge).
NOTE
• Before you charge the battery via computer,
make sure that your computer is turned on.
• While the device is connected to a computer, it
can’t be operated manually.
• When the low battery icon is displayed,
charge the device promptly.
• If you charge your device via computer instead
of using a power supply unit, the charging
speed might slow down due to a lower charg-
ing current. For fast charging, use a USB power
supply unit (not included).
X A charging battery icon appears on the screen and the
Record/Status LED ashes orange for a few seconds.
Turn the device on and o
To turn the device on or o:
• Slide and hold the Power switch on the right side of the
device downwards for three seconds.
Key lock
You can lock your device when it’s active to prevent any un-
wanted device operations or access.
To lock the device:
• Slide the Power switch on the right side of the device up-
wards towards the lock symbol.
X The lock symbol appears on the screen for a moment.
X All buttons are locked now.
8
To Next Page
Loading...
Need help?
General
