Philips VR285/07 - Manual Channel Search; Allocating a Decoder

Manual channel search
In certain cases the ’Automatic channel search’ may not be
able to find all of the TV channels (e.g. coded TV channels). In
that case, use this manual method to set the TV channels.
1 Switch on the TV set. Press the AUTOINSTALL button on
the video recorder.
2 With the P q ot P r button, select ’MANUAL SEARCH’.
Confirm with the OK button.
3 Hold the P q button until you have found the right TV
channel. A changing channel number or frequency will
appear on the TV screen.
4 Confirm with the OK button.
5 With the P q or P r button or the digit buttons 0-9 ,
select the programme number that you wish to give to this
TV channel (e.g.: ’P 01’).
6 Confirm with the OK button.
If you want to allocate more TV channels, repeat steps 3
to 6 until all TV channels have been stored.
7 To end, press the STANDBY m button.
Note: Channel number or frequency can also be entered
directly at step 3 , using the 0-9 buttons.
* To enter a special/hyperband channel, first enter the
channel digit ’9’. The indication changes from ’CH’ to ’CA’.
For example, for special channel ’S 30’, enter ’9 30’.
* Allocating a decoder: If you want to allocate a decoder,
press the INDEX E button at step 3 until ’DEC’ appears in
the display.
12