Philips WelcomeEye Connect 2 - Visit Memory and Recording Features

EN11
WelcomeEye Connect 2 / Touch / V1
1. Visit memory function
a b c
a: Photo record of a visitor.
b: Video recording of a visitor (there must be a formatted micro SD card in the monitor).
c: Deactivation of the visit memory function.
2. Video recording conguration (valid if video mode has been selected)
Choose the video recording time (10, 20 or 30 sec) during a missed call or in monitoring
mode (note: Function inactive without a micro SD card for the WelcomeEye Touch. Function
always active for the WelcomeEye Connect 2).
3. Photo conguration (valid if photo mode has been selected)
Choose the number of photos taken (1, 2 or 3) during a missed call or in monitoring mode.
4. Deactivating silent mode
This function turns o the monitor ringtone for a certain period (snooze, etc.). The monitor's
LEDs will continue to ash to signal a call.
a b c
a: activate (On) / deactivate (O)
silent mode monitor
b: Time when the ringtone will be deactivated.
c: Time when the ringtone will be reactivated.
5. Answering system function (only on WelcomeEye Connect 2, valid if video mode has
been selected)
This function allows you to record a voice message which will be played if the call is not
answered. Video recording must be congured during calls to activate this function.